DIY GPS Mount for Your Motorcycle!

Fabricate your own GPS mount on your motorcycle using parts you probably already have around the house!

Parts you will need to make the GPS dock:
– 3/16″ x 2″ Bolt
– Rubber Washer (Make sure fits snug in hole)
-Nut
-Triple Tree hole plug (Comes with bike)
-Mounting Bracket for GPS (Nuvi 1690)
-Suction cup mount (Usually Comes with GPS)

Instructions!

Step #1
Drill a 3/16″ hole in the center on the triple tree cap.

Step #2
Drill a 3/16″ hole in the rubber bottom of the suction cup mount aprox 1/2″ from the edge on the opposite side of where the lever is.
Tip: Make sure the lever is up or you will not be able to pull the rubber down to put the bolt in.

Step #3
Pull the rubber back and push the bolt in. It should be very snug as you push the bolt in.
Tip: Again make sure the lever is up or you will not be able to pull the rubber down.

Step #4
Screw the bolt through the triple tree cap. If the bolt slides in you made the hole too big!

Step #5
Put the rubber washer on the bolt, it should fit very snug as you slide it up to the bottom of the triple tree cap.

Step #6
Screw the nut up to the rubber washer and lightly tighten it with pliers. Don’t tighten it too tight!

Step #7
Push the bolt and cap all the way in in the triple tree hole. It should give you a fair amount of resistance and should fit very tight and snug.

Step #8
Snap the GPS mounting bracket onto the mounting ball.

Bonus Step#9
Attach the 12 volt charger mini USB plug into the back of the GPS mount. You will need to install a 12 volt receptacle to connect the 12 volt charger to. You can buy a 12 volt receptacle at radio Shack or online. Make sure to wire in a fuse on the positive wire before you connect it to the battery.

That’s it. EZ!